TipValve Blog

Welcome TipValve Blog, thank you for your participation.

General maintenance of Ball valve

          1. Before the disassembly, it must first be confirmed that the pressure of the pipe in the upstream and downstream of ball valve has been unloaded. Be careful to prevent damaging the sealing surface ofparts during the Disassembly and re-assembly, especially the non-metallic parts. In addition, special tools should be used to remove the O-rings. The bolts on the flange must be tightened symmetrically, successively and evenly during assembly. The cleaning agent should be compatible with rubber parts, plastic parts, metal parts and the working fluid such as gas. The petrol can be used to clean metal parts when the working medium is gas and Non-metal parts should be cleaned with pure water or alcohol.

...

The installation of ball valve

           1. The Preparation before the Installation: the pipeline before and after ball valve must be ready. The pipe around ball valve should be coaxial and the two flange sealing surfaces should be parallel. The pipe should be able to withstand the weight of ball valve. Otherwise, the pipe must be equipped with appropriate support. Purge the pipelines around the ball valve and clear out the oil, welding slag and all other impurities pipe. Check the ball valve marks if it is perfect and confirm ball valve can work normally by fully opening and closing the ball valve several times. Remove the valve protection on both ends of flange pieces. Check and clear the ball valve hole if there is any dirt. The sealing surface of ball valve seat may be damaged even if there are only small particles of foreign matter between the seat and the ball.

...

Introduction of pneumatic ball valve

           Pneumatic valve is coupled with pneumatic actuators which has relatively fast execution speed. The valve is called pneumatic quick disconnect valve due to the fastest switching speed of 0.05 seconds / time. Pneumatic ball valve usually configures various accessories, such as solenoid valves, air FRL, limit switches, positioners, and control boxes and so on. Pneumatic ball valve with these accessories can realize local control and remote central control by door switch and don’t need to go on-site or bring high altitude and risk of manual control. Time, human resources and security can be saved in large measure by this way.

...

Isolation Ball valve

           An Isolation ball valve, a type of quarter turn valve, can shut off the flow of Water and also be known as a ball fix valve. The ball valve can block the valve to stop the Water Flow. Isolation ball valves come in many sizes ranging from 0.5 cm to 30 cm to suit the pipe work in different systems.

...

Ball Valves feature zero leakage design

          Tipvalve supply with the ball valve design features Zero Leakage. The new ball valve represents the next generation in ball valves featuring zero leakage of the body, seat and stem. During development, the ball valve was subjected to extremely rigorous computer-aided analysis, laboratory and field testing. The performance of the ball valves featuring zero leakage is better than any other ball valve on the market.

...
Page:[«]1[»]

Calendar

Powered By TipValve Blog

Copyright TipValve Blog. Some Rights Reserved.